License Plate Bracket – Subaru

SEOCONTENT-START

p:gITIIJ9 M9YNTIN M96E; r9669w §T[P [69W: STEP A: APPLY ‘ADHESIVE SPACER’ TO THE “MOUNTING BRACKET” – B) ADHESIVE SPACER APPLIED TO OUTSIDE HOLES -TO ENSURE THE SPACERS ARE APPLIED TO THE REAR SIDE OF THE MOUNTING BRACKET, LOOK FOR THE PRONGS ON THE PRE-INSTALLED GROMMETS • INSERT WELL NUTS INTO THE EXISTING LICENSE PLATE MOUNTING HOLES, ON THE FRONT OF THE VEHICLE (WELL NUTS CAN BE PUSHED IN WITH A SCREWDRIVER IF THE FITMENT IS TOO TIGHT TO INSERT BY HAND). • LINE UP MOUNTING BRACKET AND ATTACH TO THE VEHICLE USING (D) SCREW #10-32 X 1,25’ • TURN CLOCKWISE UNTIL BRACKET FEELS FIRMLY SEATED AGAINST THE BUMPER- DO NOT OVERTIGHTEN • ATTACH LICENSE PLATE TO THE BRACKET USING (F) SCREW #10 X 0,5’ Pft:XITING M9UNTIN DIM?6[; 9L6OW §T[P EL9W: STEP A: APPLY “ADHESIVE SPACER” TO THE “MOUNTING BRACKET -A) MOUNTING BRACKET – TO ENSURE THE SPACERS ARE APPLIED TO THE REAR SIDE OF THE MOUNTING BRACKET, LOOK FOR THE PRONGS ON THE PRE-INSTALLED GROMMETS A) MOUNTING BRACKET FRONT LICENSE PLATE BRACKET – MOUNTING INSTRUCTIONS CONTENTS: A. (1) MOUNTING BRACKET B. (2) ADHESIVE SPACER C. (2) WELL NUT #10-32 D. (2) SCREW #10-32 X 1.25” E. (2)SCREW#10X1” F. (4) SCREW #10 X 0.5 (MOUNTING FRONT LICENSE PLATE) ( TOOLS REQUIRED: • PHILLIPS-HEAD SCREW DRIVER • 1/8” DRILL BIT – 318” DRILL BIT – DRILL THERE ARE 2 POSSIBLE MOUNTING LOCATIONS ON THIS BRACKET. ALIGN THE BRACKET TO THE MOUNTING LOCATIONS ON THE FRONT OF YOUR VEHICLE. FOLLOW STEPS ACCORDINGLY DISCLAIMER – BE SURE, WHEN INSTALLING THIS BRACKET, NOT TO BLOCK ANY ACCIDENT AVOIDANCEIPARKING SENSORS, HEADLAMPS OR VENTS TO ENGINE COMPARTMENT. 0 REV 4-15 B) ADHESIVE SPACER APPLIED TO INSIDE HOLES STEP B: ATTACH “MOUNTING BRACKET” TO VEHICLE NUT STEP B – OPTION 1: ‘LINE UP MOUNTING BRACKET TO THE DIMPLES ON THE BUMPER AND ATTACH TO THE VEHICLE USING )E) SCREW I81OX 1” ‘TURN CLOCKWISE UNTIL BRACKET FEELS FIRMLY SEATED AGAINST THE BUMPER- DO NOT OVERTIGHTEN ‘ATTACH LICENSE PLATE TO THE BRACKET USING (F) SCREW #10 X 0,5’ STEP B – OPTION 2: USING A 1/8’ DRILL BIT, CAREFULLY DRILL 2 PILOT HOLES INTO THE VEHICLES BUMPER WHERE THE DIMPLES ARE LOCATED, USING A 3/8’ DRILL BIT, CAREFULLY DRILL 718” INTO THE PILOT HOLES IA PIECE OF TAPE ON THE DRILL BIT CAN BE USED TO INDICATE DEPTH). INSERT WELL NUTS INTO THE NEWLY CREATED HOLES ON THE DUMPER, LINE UP MOUNTING BRACKET AND ATTACH TO THE VEHICLE USING (D) SCREW #10-32 K 1-25’ TURN CLOCKWISE UNTIL BRACKET FEELS FIRMLY SEATED AGAINST THE BUMPER, DO NOT OVERTIGHTEN ATTACH LICENSE PLATE TO THE BRACKET USING (F) SCREW #10 X 05’

**************************************************************************************************************

SEOCONTENT-END