Accessory Installation Guide
| 2021MY Crosstrek Fog Light Kit | H4510FL100 |
Installation Instructions – French
CROSSTREK FOG LAMP KIT
(2021MY and after)
INSTALLATION INSTRUCTION
PART No. H4510FL100
IMPORTANT
1. The installation should be carried out by an authorized Subaru
dealer.
2. Pay special attention not to damage vehicle components when removing / installing them.
3. Route the wiring so that it cannot be abraded against any sharp edges.
4. Refer to the vehicle service manual.
5. Check that the vehicle’s electronic devices are operating normally. Be sure to make note of the contents of the memory of electronic devices such as the preprogrammed radio channels.
SEOCONTENT-START
1
CROSSTREK FOG LAMP KIT (2021MY and after) INSTALLATION INSTRUCTION
PART No. H4510FL100
IMPORTANT
1. The installation should be carried out by an authorized Subaru
dealer.
2. Pay special attention not to damage vehicle components when removing / installing them.
3. Route the wiring so that it cannot be abraded against any sharp edges.
4. Refer to the vehicle service manual.
5. Check that the vehicle’s electronic devices are operating normally. Be sure to make note of the contents of the
memory of electronic devices such as the preprogrammed radio channels.
2
Components
① ②
③ ④ ⑤ ⑥ ⑦
???????? ???????? ×2
Tools
10mm 10mm
3
After removing the battery terminal, wait 60
seconds before proceeding to the next procedure.
1 2
C63:x4
C63(L)
3
C63:x7
C63(L)
4
5
3
6
4
4
Rear of lower instrument panel shown.
4
7
9
11
13 14
12
8
2 A
A
10 5
6 7
1
5
16
15
3m[10ft]
Bulb center marking
40mm[1.57in]
Height of fog light center
Vehicle center
Vehicle
center
40mm[1.57in]
Height of
fog light
center
**************************************************************
KIT DE FEUX ANTIBROUILLARD CROSSTREK
(2021MY et après)
INSTRUCTIONS D’INSTALLATION
Numéro de pièce H4510FL100
IMPORTANT
1. L’installation doit être effectuée par un concessionnaire Subaru
autorisé.
2. Faites particulièrement attention à ne pas endommager les composants du véhicule lors de leur retrait /
installation.
3. Acheminez le câblage de manière à ce qu’il ne puisse pas être abrasé contre des bords coupants.
4. Reportez-vous au manuel d’entretien du véhicule.
5. Vérifiez que les appareils électroniques du véhicule fonctionnent normalement. Assurez-vous de prendre note du
contenu dumémoire d’appareils électroniques tels que les canaux radio préprogrammés.
1
???????? ????????
Composants
③
①
④ ⑤
②
⑥ ⑦
×2
Outils
10mm 10mm
2
1
Après avoir retiré la borne de la batterie, attendez
60 secondes avant de passer à la procédure
suivante.
2
C63(L)
C63:x4
3
C63(L)
4
C63:x7
Arrière du tableau de bord inférieur illustré.
4
3
4
3
5 6
1 5
6 7
11
2
12
A
A
4
7 8
9 10
13 14
15
16
Centre de
véhicules
Centre de véhicules
Marquage du centre
de l’ampoule
3m[10ft]
Hauteur du centre du feu
antibrouillard
40mm[1.57in]
40mm[1.57in]
Hauteur du
centre du
Feu
antibrouillard
5
SEOCONTENT-END
H4510FL100
H4510FL100
- 【SUPER BRIGHT & LONG LIFESPAN】55W each light, using high power 100 watts 6000K LED chips and specially designed optical lens, create combo beam pattern and makes it extremely bright even in day light. White light can have better penetration in rain and fog weather, so you can see the road ahead in rain, fog and snow weather. With LED lifespan of more than 50,000 hours, it will light your roads, garage and working areas for years to come.
- 【HIGH QUALITY HOUSING & ACCESSORIES】 Heavy duty 6063 aluminum housing, oversized heat sink keeps lights running cooler. Adjustable stainless steel mounting hard wares are rust proof and anti corruption, and you can customize the light angle. (360 degree)
- 【WATERPROOF & DUSTPROOF & SHOCKPROOF】 Built with IP68 rating, meaning that it is completely secure against both small dust particles and at least sixty minutes of being immersed in one meter of water. All lights are burn-in and waterproof tested before leaving the factory.
- 【RECOMMENDED REASON】Low power consumption, no maintenance, environmental protection. High performance price ratio, strong light intensity and Ultra low current output, Can provide enough brightness and save a lot of energy for your car.
- 【GET IT WITH CONFIDENCE】If you have any questions after purchasing, you can contact us via Amazon email. With absolutely nothing to worry about, get this amazing light for your vehicle today!
- 【Fitment】Compatible with 12-14 Subaru
Impreza (Non WRX
& STI
Models Only) - 【Easy Installation】No Drilling or Any Other Modification Needed, Convenient to Replace Old and Worn Fog Lights.
- 【Function】Enhance visibility during night time, heavy rain, snow, or dense fog, also bring a different appearance to vehicle that's great for show use or to replace old and worn fog lights
- 【Package Includes】Comes with a Complete Set of Fog Light Bezels (Driver and Passenger Side)
- 【Quality Construction】S.A.E. (Society of Automotive) and D.O.T. (Department of transportation) approved to ensure the quality and fitment
- 【BRIGHTER DUAL COLOR LED FOG LIGHTS】Led fog lights with premium 30W LEDs, 3600LM 6500K white & 3500K yellow dual color,way brighter and longer-lasting than s factory halogen and hid fog light bulbs. The powerful high-intensity beams pierce through thick fog, heavy rain and low-light conditions with ease, boosting your road clarity and making your vehicle more visible to others, effectively elevating overall driving safety
- 【WIDE VEHICLE COMPATIBILITY】These round LED fog lights fit a wide range of vehicles, perfect fit for 2016-2018 Honda Pilot, 2013-2015 Honda CR-V, CR-Z, Crosstour, Accord and Civic, 2015 Fit, 2018-2019 Honda Odyssey, 2014-2019 Honda City, 2019 Honda Ridgeline; 2014-2017 Ram Promaster;2017-2018 JEEP Cherokee, 2014-2017 JEEP Compass; 2012-2018 Fiat 500, 2009-2012 Fiat Punto Evo; 2005-2010 Chrysler 300;2010-2018 Acura RDX, 2013-2018 Acura ILX, 2012-2014 Acura TL, and 2011-2014 Acura TSX
- 【PLUG AND PLAY】These fog lamps come with a 9005 plug for true plug-and-play functionality, enabling hassle-free installation in just 15 minutes. The kit includes a 5202/H16 adapter to effortlessly convert the 9005 connector to 5202, supporting direct replacement of your OEM fog lights—no drilling, cutting or splicing required at all. Adjustable angle screws let you fine-tune the light position up and down, optimizing your driving visibility for a safer, upgraded experience
- 【DURABLE & LONG-LASTING】Our fog lights built tough with military-grade die-cast aluminum housing, IP67 waterproof and impact-resistant to withstand rain, mud & rough roads, lasting over 50,000 hours for non-stop reliable performance
- 【STYLISH & PRACTICAL】Upgraded subaru
fog lights with a sleek design—angel eye black fog lights seamlessly integrate with your car’s front bumper, elevating its overall aesthetic. Replace dim factory fog lights with these high-intensity, ultra-bright LED units: they boost light output dramatically, cutting through low-visibility conditions (fog, rain, dusk) to enhance driving safety
- ✔Exact OEM Fit: Direct fitment for fog lights OEM lenses with no complex modifications. Fog lights fit 2015-2017 Subaru
Legacy. The foglights are sold in a pair: include left side (driver side) and right side (passenger side). - ✔Excellent Quality: Fully sealed, waterproof, dust and corrosion resistant made the fog lights perform well and prevent moisture and dust from getting inside the fog light housing.
- ✔Bright Illumination: The fog lights come with one pair of H16 12V 19W light bulbs (the bulbs are already pre-installed in the fog lights), which allow you to see and be seen by oncoming drivers even through a thick fog.
- ✔Easy Installation: Easy to install. The fog lights are designed for quick and easy installation (Switch and wiring kit are included in the package). Needn't for any modifications.
- ✔DOT/SAE Compliance: The fog lights own SAE compliance and DOT approval. Thoroughly tested to meet federal and international standards, the fog lamps are fully street legal.
- Part: Fog Light
- Partslink number: SU2592122 / OEM number: 84501AJ060, 84912AJ310
- Position: Driver or Passenger Side
- DOT & SAE Compliant
- Brand New - Sealed in a Box
This product presentation was made with AAWP plugin.


![H4510FL100 - Fog Light Kit - 2021 Subaru Crosstrek 3 DNA MOTORING FL-ZTL-273 Front Bumper Fog Light With Bezel Driver & Passenger Side Enhance visibility [Compatible with 12-14 Subaru Impreza]](https://m.media-amazon.com/images/I/51KIKFFZk0L.jpg)


