Info
oemdtc
April 8, 2020
NHTSA ID Number: 10165553 Manufacturer Communication Number: 12-273-19 Summary This bulletin announces availability of redesigned leather seat cushion trim covers to address isolated customer concerns of wrinkles appearing during early stages of vehicle use as shown in the example photo below. The new covers utilize materials with higher durability and resistance to wrinkling.
NHTSA ID Number: 10165504 Manufacturer Communication Number: 10-179-19 Summary This Service Information Bulletin provides a procedure to “reset” the headlight leveler system. After an affected vehicle is transported on a flatbed or other type of carrier, the headlight beam adjustment may become either too high or too low. During normal operation, system sensors measure inclination of the road surface in comparison to …
Info
oemdtc
April 8, 2020
NHTSA ID Number: 10169866 Manufacturer Communication Number: 16-126-19 Summary This bulletin announces a design change to the leather transmission selector lever grip. The change will address a small number of concerns regarding stickiness and / or roughness felt on a portion (Panel A shown in the illustration below) of the grip surface. The new part also enhances parts commonality among models.
NHTSA ID Number: 10171917 Manufacturer Communication Number: 11-197-20 Summary This bulletin announces availability of reprogramming files to optimize the Engine Control Module (ECM). These new files address concerns of the check engine light coming on and setting a DTC P0400: EGR “A” FLOW. The DTC can set if the ECM tests the EGR system when ambient / intake air temperatures are below …
NHTSA ID Number: 10171918 Manufacturer Communication Number: 11-198-20 Summary This bulletin announces availability of reprogramming files to optimize the engine’s electronic control module (ECM). These new files address concerns of the check engine light coming on and setting any of the following DTCs for Air-Fuel Ratio Imbalance: P219C, P219D, P219E or P219F. The ECM parameters for air-fuel (A/F) calculation have been revised.
NHTSA ID Number: 10171919 Manufacturer Communication Number: 11-199-20 Summary This bulletin announces availability of reprogramming files to optimize the Engine Control Module (ECM). The new logic will address isolated concerns of a hard start condition occurring in cold weather (+10 degrees Fahrenheit or lower) and / or high-altitude areas. When this scenario occurs, the A/F learning control values move toward lean.
