| “This site contains affiliate links for which OEMDTC may be compensated” |
NUMBER: 06-50-15
DATE: 08/10/15
| APPLICABILITY: | 2014-15MYForester Models |
| 2012-15MY Impreza and XV Crosstrek Models (EXCEPT Hybrid) | |
| SUBJECT: | Design Changes to Master Cylinder and Brake Booster |
INTRODUCTION
This bulletin informs of a parts change to the brake system Master Cylinder and Vacuum Booster. Whenever replacement of either of these components is required, the identification procedure provided below must be followed to insure the proper parts are ordered and installed as a set.
PRODUCTION CHANGE INFORMATION:
The new master cylinder and vacuum booster were incorporated into production as per the table below. There are 3 columns of VIN information in the table below. To clarify:
- Before Change: “Old” parts only were used in production.
- Transition Period: “Old” parts (combination of old master cylinder and old vacuum booster) or “New” parts (combination of new master cylinder and new vacuum booster) may have been used in production. (New and old parts were never and cannot be combined.)
- After Change: “New” parts only were used in production.
| MODEL | SEDAN / WAGON | STARTING VIN BEFORE CHANGE | TRANSITION PERIOD VIN RANGE | STARTING VIN AFTER CHANGE |
|---|---|---|---|---|
| Impreza / XV Crosstrek (except hybrid) | 4-Door | F*009362 | F*009363 to F*009379 | F*009380 |
| 5-Door | F*234518 | F*234519 to F*235315 | F*235316 | |
| Forester | All | F*574366 | F*574367 to F*575794 | F*575795 |
PART INFORMATION
Master Cylinder Assembly
| NEW PART NUMBER | TRANSMISSION | MODEL APPLICABILITY | OLD PART NUMBER |
|---|---|---|---|
| 26401FJ120 | M/T | All | 26401FJ061 |
| 26401FJ130 | CVT | 26401FJ071 |
Vacuum Booster Assembly
| NEW PART NUMBER | VACUUM SENSOR | MODEL APPLICABILITY | OLD PART NUMBER |
|---|---|---|---|
| 26402FJ110 | WITHOUT | All | 26402FJ010 |
| 26402FJ130 | WITH | 26402FJ030 |
IMPORTANT NOTES:
- “New” and “Old” part number parts are NOT interchangeable and must never be used in combination.
- A “new” part number Master Cylinder assembly MUST ONLY be used with a “new” part number Vacuum Booster assembly.
- An “old” part number Master Cylinder assembly MUST ONLY be used with an “old” part number Vacuum Booster assembly.
- The “old” part numbers WILL NOT supersede to the “new” part numbers.
SERVICE PROCEDURE / INFORMATION
CAREFULLY inspect the 5 digit ID located on the front of the Master Cylinder to determine if it is a “new” or “old” part. If the ID is: FJ120 or FJ130, it is a “new” part.
If there is a white dot paint marking on the Vacuum Booster, it is a “new” part.
NOTE: It is especially important to verify the ID of both parts on vehicles with VINs found to be within the Transition Period. Whenever unable to positively identify either component, replace BOTH as a set using the “new” part number parts.
Follow the Service procedure in the applicable Service Manual for replacement of the Master Cylinder and Vacuum Booster assemblies.
WARRANTY / CLAIM INFORMATION
For vehicles within the Basic New Car Limited Warranty period or with an active Added Security Classic or Gold Service Agreement, this repair may be claimed using the following information:
| MODEL | LABOR DESCRIPTION | LABOR OPERATION # | FAIL CODE | LABOR TIME |
|---|---|---|---|---|
| Forester, Impreza and XV Crosstrek | MASTER CYLINDER AND BOOSTER REPLACEMENT FOR PEDAL TRAVEL | A533-291 | QBB-43 | 2.8 |
| Forester Turbo | 3.0 |
REMINDER: SOA strongly discourages the printing and/or local storage of service information as previously released information and electronic publications may be updated at any time.
Always refer to STIS for the latest service information before performing any repairs.
Loading...
Reload document 
Open in new tab
