“This site contains affiliate links for which OEMDTC may be compensated” |
NHTSA ID Number: 10054221
Manufacturer Communication Number: SB-07-59-07R
Summary
SUBARU: THE FORMATION OF MOISTURE AND/OR CONDENSATION, INSIDE OF REAR COMBINATION AND HEADLAMPS, IS TEMPORARY, AND WILL EVAPORATE WHEN TEMPERATURE RISES INSIDE LAMPS. MODEL ALL. NO YEARS LISTED. *PE
NUMBER: 07-59-07R
DATE: 12/17/07
REVISED: 11/21/13
APPLICABILITY: | All Current Models |
SUBJECT: | Moisture / Condensation (Water) Formation Inside Exterior Lamp Assemblies |
INTRODUCTION
This bulletin is for information purposes only. Due to design changes of the headlamps and rear combination lamps, moisture and / or condensation formation may develop on the inside of the lamp lenses. The moisture formation is only temporary and will disappear (evaporate) when the temperature inside the lamp assembly rises. Replacement of headlamp and / or rear combination lamp assemblies for this condition is not a matter for warranty.
Moisture Formation
This condition is most noticeable and commonly occurs in the late fall and early spring. It develops when there are significant temperature differences between the evening and morning or, when washing a vehicle with cold water on a sunny day when the lamps are already warm. This is the same basic scenario which causes dew formation on the inside surfaces of window glass.
Examples
1) If a lamp is unevenly warmed by sunshine as shown in the illustration below, temperature of the area where the sun shines can be about 50° F higher than the other (cold) area. When air circulates inside the lamp, the warm air reacts to the cold surface resulting in formation of condensation.
2) If an already warm lamp lens gets cooled down rapidly (e.g. when water is applied to the lens during vehicle washing), a sudden temperature change can occur resulting in the development of condensation.
15 Affected Products
Vehicles
MAKE | MODEL | YEAR |
SUBARU | BRZ | 2013 |
SUBARU | FORESTER | 2012-2014 |
SUBARU | IMPREZA | 2012-2013 |
SUBARU | LEGACY | 2012-2014 |
SUBARU | OUTBACK | 2012-2014 |
SUBARU | TRIBECA | 2012-2013 |
SUBARU | XV CROSSTREK | 2013 |
1 Associated Document
Service Bulletin Document
NUMBER: 07-59-07R
DATE: 12/17/07
REVISED: 11/21/13
https://www.nhtsa.gov/recalls?nhtsaId=10054221
SB-10054221-3864.pdf 319.204KB
NHTSA ID Number: 10235895
Manufacturer Communication Number: 075907R
Summary
Moisture / Condensation (Water) Formation Inside Exterior Lamp Assemblies
1 Associated Document
Manufacturer Communications
NUMBER: 07-59-07R
DATE: 12/17/07
REVISED: 11/21/13
https://www.nhtsa.gov/recalls?nhtsaId=10235895
MC-10235895-9999.pdf 556.372KB
- Tail light assembly replacement for 2014-2016 Subaru Forester right passenger side
- Part Number: 84912SG041, SU2819105
- It has better wear resistance, and aesthetics thats great for show use or to replace old and worn tail light
- Special coating on the lens surface prevents hazing and fading, safe to see at night or in bad weather
- Plug and play installation, perfect match for your tail lights, no wiring or any other modification needed
- Replacement for 2014-2016 Subaru Forester right side tail light
- Weather-sealed housing to prevent moisture intrusion, performance tested for poor weathers
- It has better wear resistance, reflectivity, aging resistance, and aesthetics thats great for show use or to replace old and worn tail light
- Made of high-quality materials, the edges and back are well sealed, waterproof and dustproof, keep lighting in rain or snow
- Easy to install. No need additional hardware. Plugs right into the existing wiring harness for simple, fast and easy installation
- Part Number: 84912SG051, SU2818105; Package Included: 1x Rear Driver Side Tail Light (LH).
- This rear lamp is plug and play, Replacement for 2014-2016 Subaru Forester tail light lamp.
- The tail lights have good sealing, strong durability, and uniform illumination, improving the safety of driving at night.
- This type of taillight can provide sufficient brightness for your vehicle, replacing old or damaged taillights, and bringing a clear signal to your vehicle.
- Before purchasing this product, please verify whether the year and model match correctly.
- Replacement for 2014-2016 Subaru Forester left side tail light
- Weather-sealed housing to prevent moisture intrusion, performance tested for poor weathers
- It has better wear resistance, reflectivity, aging resistance, and aesthetics thats great for show use or to replace old and worn tail light
- Made of high-quality materials, the edges and back are well sealed, waterproof and dustproof, keep lighting in rain or snow
- Easy to install. No need additional hardware. Plugs right into the existing wiring harness for simple, fast and easy installation
- Fitness: These back lights are compatible with Toyota 86 2012 2013 2014 2015 2016 2017 2018 2019 2020. Subaru BRZ 13 14 15 16 17 18 19 20, Scion FRS 2013 2014 2015 2016. Please keep all user manuals, barcode on box or on the lights. If you have issues with our lights, please just contact us.
- Plug and Play: Back lamp or taillights are easy to install. Designed to be an exact replacement for your factory lights. No splicing required. Professional installation is recommended. If you have issues with installation, please confirm with us.
- Benefits: LED reverse lights, fog light, super bright. Refresh the look of your car and change your car style, and gives you and your family safer night-time driving. Including turn signal with sequential indicator, LED daytime running light.
- Quality Assurance:DOT or SAE , FMVSS 108 certification, with PC, ABS, PMMA, GLASS Material Prove Fully Sealed, Waterproof, Dust and Corrosion Resistant, working perfectly even in harsh weather conditions. OEM - 116477001, SC2819109, 116478001, SC2818109. Partslink #: 11647700, 11647800, 11647801, 11647701.
- You will get: One user manual, two wire harnesses. Two tail lights driver side and passenger side. 12-month after-sale services.
- Aftermarket Replacement Tail Light Compatible With 2017-2018 Subaru Forester
- Replaces OE Number: 84912SG151-PFM
- Features: OE comparable, Halogen, With bulb(s)
- Interchange Part Number: 84912SG151, SU2818109, 84912SG151-PFM
- A high quality, Direct Fit OE Replacement Tail Light, with FREE 1-year UNLIMITED mileage warranty coverage on Garage-Pro items.
- Aftermarket Replacement Tail Light Compatible with 2010-2014 Subaru Outback
- This Evan-Fischer Tail Light is a replacement for OE, Original Equipment, 84912AJ10A Partslink, SU2804105
- Location: Driver Side, Outer, Lens: Clear & Red Lens
- Tail Light Bulb: Halogen
- This tail light purchased through AutoPartsGiant comes with a 1 year warranty
- 🚗 Replacement for 2011-2021 Subaru WRX STI,2011-2016 Subaru Impreza, 2013-2021 Subaru XV Crosstrek, Replace OEM # 84913FG420 84913-FG420.
- 🚗 100% Brand New Smoked Lens with Red Led , Powered by 12pcs Red led lights for the Rear Fog Light with Brake/Tail Feature, and 4pcs White Led Lights for Backup Reverse.It is 3 times more brighter than Factory one
- 🚗 Wiring Guide:black wire to the ground, red to the brake light, green wire to running light,white to the reverse light. Color of the wires may vary when you receive. Color of the wires may vary when you receive. Before installion,Testing each wire to connect them accordingly is highly
- 🚗 Complete kit comes with LED rear fog light, wiring harness, back mounting bracket, taps and screws
- 🚗Free one year warranty.Free one year warranty.If you have any questions,please feel free to contact us.Thanks very much!!!
- 【HUGE IMPROVEMENT】- Yorkim 7443 LED bulb is built with 33-SMD 2835 LED chips, 300% Brighter than halogen bulbs, provides lots more light when going in brake
- 【EASY INSTALLATION】- The width of this 7443 led bulb is smaller than halogen bulb, makes it easier to intall, just remove the original bulb and insert this 7443 LED bulb, plug and play in 10 minutes, no different than installing a normal bulb
- 【FITMENT】- Fit for 7443 7440 7440A 7440NA 7440SV 7443NA 7441 7443R 7444 992 WY21W W21W ect, replacement for Brake Lights, Tail Lights, Parking Lights, Turn Signal Lights, Side Marker Lights, etc. Extra load resistor might be needed to solve the hyper flashing.
- 【LOW CONSUMPTION】- Voltage: 9-30V. Total output: 3300 Lumen. Watt: 3.6W per bulb, only 1/5 energy consumption of original bulb but 3 times brighter. Full Aluminum Housing with Projection lens for Maximum Light output, Built-in smart IC driver for constant current and better heat distribution
- 【PLS NOTE】- The bulb size may vary between trim of your vehicle, Please confirm the bulb's size or check owner's manual to verify compatibility before purchase. Any problem, please feel free to contact us, we are always here to service for you
Last update on 2024-04-19 / Affiliate links / Images from Amazon Product Advertising API
This product presentation was made with AAWP plugin.
SEOCONTENT-START
Bulletin Number: 07-59-07; Date: 11/21/13 Page 1 INTRODUCTION This bulletin is for information purposes only. Due to design changes of the headlamps and rear combination lamps, moisture and / or condensation formation may develop on the inside of the lamp lenses. The moisture formation is only temporary and will disappear (evaporate) when the temperature inside the lamp assembly rises. Replacement of headlamp and / or rear combination lamp assemblies for this condition is not a matter for warranty. Moisture Formation This condition is most noticeable and commonly occurs in the late fall and early spring. It develops when there are significant temperature differences between the evening and morning or, when washing a vehicle with cold water on a sunny day when the lamps are already warm. This is the same basic scenario which causes dew formation on the inside surfaces of window glass. NUMBER: 07-59-07R DATE: 12/17/07 REVISED: 11/21/13 APPLICABILITY: All Current Models SUBJECT: Moisture / Condensation (Water) Formation Inside Exterior Lamp Assemblies continued… CAUTION: VEHICLE SERVICING PERFORMED BY UNTRAINED PERSONS COULD RESULT IN SERIOUS INJURY TO THOSE PERSONS OR TO OTHERS. Subaru Service Bulletins are intended for use by professional technicians ONLY. They are written to inform those technicians of conditions that may occur in some vehicles, or to provide information that could assist in the proper servicing of the vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do the job correctly and safely. If a condition is described, DO NOT assume that this Service Bulletin applies to your vehicle, or that your vehicle will have that condition. SUBARU OF AMERICA, INC. IS “ISO 14001 COMPLIANT” The international standard for excellence in Environmental Management Systems. Please recycle or dispose of automotive products in a manner that is friendly to our environment and in accordance with all local, state and federal laws and regulations. SERVICE BULLETIN ATTENTION: GENERAL MANAGER q PARTS MANAGER q CLAIMS PERSONNEL q SERVICE MANAGER q IMPORTANT – All Service Personnel Should Read and Initial in the boxes provided, right. Bulletin Number: 07-59-07; Date: 11/21/13 Page 2 Examples 1) If a lamp is unevenly warmed by sunshine as shown in the illustration below, temperature of the area where the sun shines can be about 50° F higher than the other (cold) area. When air circulates inside the lamp, the warm air reacts to the cold surface resulting in formation of condensation. Dew Formation Cold Area Circulation Hot Area 2) If an already warm lamp lens gets cooled down rapidly (e.g. when water is applied to the lens during vehicle washing), a sudden temperature change can occur resulting in the development of condensation. 2) Water cools down the lens. 3) Dew formation. 1) Inside of lamp is heated by sunshine.
**************************************************************************************************************
**************************************************************************************************************
SEOCONTENT-END