Change to Door Glass Retaining Bolts – 2013-2015 Subaru BRZ

“This site contains affiliate links for which OEMDTC may be compensated”

NUMBER: 12-180-15
DATE: 08-24-15

 

 APPLICABILITY: 2013-15MY BRZ
SUBJECT: Change to Door Glass Retaining Bolts

 

INTRODUCTION

This Service Information bulletin announces a change to the retaining bolt securing the door glass to the window regulator assembly.  A slot to accept a flat-blade screw driver has been added to the end of the bolt to keep it from spinning while removing the retaining nut during door glass assembly R&R.

 

PRODUCTION CHANGE INFORMATION:

The slotted bolts were incorporated into production in September, 2014 starting with VIN: F*602206.

 

PART INFORMATION

PART NUMBER DESCRIPTION
61011CA001 Door Glass Assy RH
61011CA011 Door Glass Assy LH

 

TOOL REQUIREMENT:

A special, thin (1.8mm) open-end 14mm wrench must be used to keep the glass retaining bolt from spinning while removing the retaining nut.  This essential Subaru Special Tool, # SOA321105 will be shipped to each retailer.  Replacements or extras can be ordered by accessing the Bosch Service Solutions website:  Subarunet > Service > Special Service Tools.

A special, thin (1.8mm) open-end 14mm wrench

 

SERVICE PROCEDURE / INFORMATION

  • CAREFULLY remove the door trim panel following the procedure in the applicable Service Manual and set it aside in a safe place to avoid damage.
  • CAREFULLY remove the vapor barrier only as much as necessary to access the door glass retaining bolts.

The illustrations below show both the pre and post-production change glass retaining bolt.

pre and post-production change

pre and post-production change

 

NOTE:  If the vapor barrier is damaged during the repair, it must be replaced.

REMINDER:  SOA strongly discourages the printing and/or local storage of service information as previously released information and electronic publications may be updated at any time.

Always refer to STIS for the latest service information before performing any repairs.


https://static.nhtsa.gov/odi/tsbs/2015/SB-10092530-2280.pdf

Loader Loading...
EAD Logo Taking too long?

Reload Reload document
| Open Open in new tab

Download [565.51 KB]

 


 

Leave a Comment

1
Share to...