Accessory Installation Guide
2024MY Impreza/Crosstrek – Auto-Dimming Mirror with Compass and HomeLink | H501SFN000 |
Installation instructions
Instructions d’installatiion
Part number:
Numéro de piéce:
H505SFN000
Vehicle:
Véhicule:
Crosstrek/ Impreza
1
Disconnect battery cable from the negative battery stud.
Débranchez le câble de la batterie de la borne négative de la batterie.
2
Remove cover with panel removal tool
Retirez le couvercle à l’aide de l’outil de dépose de panneau
3
Remove 2 screws
Enlevez 2 vis
4
Pull assembly down to disengage
Tirez l’ensemble vers le bas pour le désengager
5
Push Eyesight cover forward to release the clips
Poussez le couvercle EyeSight vers l’avant pour libérer les attaches
6
Firmly grasp the factory mirror and remove by rotating the base and pulling away simultaneously from the windshield mounting button.
Saisissez fermement le rétroviseur d’origine et retirez-le en tournant la base et en l’écartant simultanément du bouton de fixation du pare-brise.
7
Push lower eyesight cover forward to disengage clips and remove
Poussez le couvercle EyeSight inférieur vers l’avant pour désengager les attaches et le retirer
8
1. Install the Compass mirror with HomeLink by aligning the mirror retention clips with the windshield mirror button and pressing against the mirror to fully seat the mirror.
2. Rotate the mirror until properly aligned with the reference notch shown
1. Installez le rétroviseur à boussole équipé d’HomeLink en alignant les attaches de fixation du rétroviseur avec le bouton de pare-brise du rétroviseur, puis en pressant suffisamment sur le rétroviseur pour bien le positionner.
2.Tournez le rétroviseur jusqu’à ce qu’il soit bien aligné avec la référence
9
Route mirror connector over eyesight module and slide onto connector tab
Acheminez le connecteur du rétroviseur par-dessus le module EyeSight et glissez-le vers languette du connecteur
10
1. Plug jumper harness into pre-wire connector and mirror and
2. Collect and tape excess harness to sheet metal using foam tape and zip tie
1. Branchez le faisceau cavalier dans le connecteur de précâblé et dans le rétroviseur et
2. Ramassez l’excédent de faisceau puis collez-le sur la tôle à l’aide de ruban mousse et attachez-le
11
Re-install lower eyesight cover by setting up and pulling rearward
Réinstallez le couvercle inférieur EyeSight en le soulevant et en le tirant vers l’arrière
12
Plug in connectors
Branchez les connecteurs
13
Re-install 8mm bolts
Réinstallez les boulons de 8 mm
14
View of reinstalled components
Vue des composants réinstallés
15
Reconnect battery. If equipped reconnect eyelet cable. Tighten bolt to 66 in-lbs.
Rebranchez la batterie. Si elle en est équipée, rebranchez le câble de l’oeillet. Serrez les boulons à 66 po-lb.
16
Using dark cloth or cardboard, completely cover forward-looking sensor.
Avec un linge sombre ou un carton, couvrez complètement le capteur pointé vers l’avant.
17
To calibrate compass reference mirror user guide.
Pour étalonne la boussole, reportez-vous au manuel du rétroviseur.
H501SFN000
https://static.oemdtc.com/AccessoryInstallationGuide/H501SFN000.pdf
H501SFN000
- Genuine Subaru Auto-Dimming Mirror with Compass and Homelink
- H501SSG305 (have non homelink in our store)
- his upgraded auto-dimming mirror detects glare and darkens automatically to protect your vision, while featuring an 8-point digital compass. Three backlit HomeLink buttons can be programmed to operate most garage doors, security gates, home lighting and more. Can also provide you with the last status of your garage door (open or closed) if programmed to a compatible opener featuring two-way communication.
- 2017-2022 Legacy 2017-2022 Outback (2019 2020 2021 2022 BASE & PREMIUM MODELS)
- 2017-2023 Impreza 2018-2021 Forester 2019-2023 Ascent 2018-2023 Crosstrek
- Package Dimensions: 13.208 H x 27.94 L x 13.716 W (centimetres)
- Designed to work specifically with your vehicle
- Package Weight: 0.408 kilograms
- Country of Origin : United States
- High quality
- Designed to work specifically with your vehicle
- Guaranteed against poor workmanship and material defects
- 2014 Subaru Xv Crosstrek
- This product parts meet tested safety requirements and match Subaru proven performance standards
- This product helps provide a trusted installation and lasting life
- This product is manufactured in United States
- Genuine Subaru OEM
- Genuine OEM
- High quality
- Dependability
- H501SXA130 Genuine Subaru Inside Rear View Mirror Harness Cover Cap
- THERE IS 3 DIFFERENT SIZES SUBARU MAKES , this is the "long "one we have all 3 in our store. THIS ONE IS CLOSED TOTAL LENGTH 5 INCHES , EXTENDS TO 8 INCHES. TOP RECTANGLE BACK IS 3 3/8 LONG)
- 2008-2019 Impreza 2008-2013 Forester 2017-2020 Forester 2019-2020 Ascent 2017-2020 Brz
- 2013-2016 Crosstrek 2018-2020 Crosstrek
- 2010-2020 Legacy 2010-2020 Outback 2010-2014 Tribeca 2015 2016 Wrx Sti 2019-2020 Wrx Sti
- Country/Region Of Manufacture: United States, Returns Accepted: Returns Accepted, Year: 2014 2015 2016, Modified Item: No
- Features: Auto Dimming,Compass,Homelink, Fitment Type: Direct Replacement, Notes: Wire Harness, Model: Forester
- Oe Spec Or Performance/Custom: OE Spec, Oe/Oem Part Number: H501SSG010, Certifications: OE, Brand: Compatible with Subaru
- Manufacturer Part Number: H501SSG010, Manufacturer Warranty: 1 Year, Part Brand: Compatible with Subaru, Make: Compatible with Subaru
- 【Auto Adjusting Brightness & Auto Dimming Mirror】 This display automatically adjusts its brightness according to the surrounding. The mirror will Auto Dim when bright lights are behind the vehicle, it will automatically reduce the glare at night, ensuring driving safety and protecting your eyesight.
- 【Compass & Temperature】 Built in PathPoint Compass and Outside Temperature sensor displayed on the upper right corner.
- 【4.3" Display Mirror】Provides rear vision and backup display simultaneously while reversing enhances driver safety.(BACKUP CAMERA NOT INCLUDED)
- 【Easy to install】Universal fit for most vehicle model, for factory looks and great quality interior mirror: When monitor is off, almost no frame is shown on the mirror. The reflection of the mirror is perfect. This rear view mirror come with 3 options mirror bracket adapter, so it will fit for most car models like Toyota, Ford, Honda, Nissan, Mazda, Hyundai, kia, Chevrolet and etc.
- 【OEM Look Rearview Mirror Monitor】This 4.3 inch Auto Dimming Mirror with Compass Temperature Mirror Monitor with a OEM bracket mounting can replace your original mirror completely without any damage or vibration.
Last update on 2023-05-11 / Affiliate links / Images from Amazon Product Advertising API
This product was presentation was made with AAWP plugin.
SEOCONTENT-START
Installation instructions Instructions d’installatiion Auto dimming mirror Tetroviseur antieblouissement Tools required Outils requis Part number: Numéro de piéce: Kit contents Contenu de la trousse H505SFN000 Description: Auto dimming mirror Description: Tetroviseur antieblouissement ISSUE A PAGE 1/6 DATE 6/1/2022 SUBARU OF AMERICA A Panel removal tool Outil de dépose du panneau Vehicle: Crosstrek/ Impreza Véhicule: 10 mm PART NUMBER H505SFN000 B C D Wire harness Faisceau de câblage Wire Tie Attache autobloquante Foam Tape Ruban mousse ISSUE A SUBARU OF AMERICA PART NUMBER H505SFN000 DATE 6/1/2022 1 Disconnect battery cable from the negative battery stud. Débranchez le câble de la batterie de la borne négative de la batterie. PAGE 2/6 10 mm 3 Remove 2 screws Enlevez 2 vis 2 Remove cover with panel removal tool Retirez le couvercle à l’aide de l’outil de dépose de panneau 4 Pull assembly down to disengage Tirez l’ensemble vers le bas pour le désengager ISSUE A SUBARU OF AMERICA PART NUMBER H505SFN000 DATE 6/1/2022 PAGE 3/6 5 Push Eyesight cover forward to release the clips Poussez le couvercle EyeSight vers l’avant pour libérer les attaches 6 Firmly grasp the factory mirror and remove by rotating the base and pulling away simultaneously from the windshield mounting button. Saisissez fermement le rétroviseur d’origine et retirez-le en tournant la base et en l’écartant simultanément du bouton de fixation du pare-brise. 7 Push lower eyesight cover forward to disengage clips and remove Poussez le couvercle EyeSight inférieur vers l’avant pour désengager les attaches et le retirer 1 2 8 1. Install the Compass mirror with HomeLink by aligning the mirror retention clips with the windshield mirror button and pressing against the mirror to fully seat the mirror. 2. Rotate the mirror until properly aligned with the reference notch shown 1. Installez le rétroviseur à boussole équipé d’HomeLink en alignant les attaches de fixation du rétroviseur avec le bouton de pare-brise du rétroviseur, puis en pressant suffisamment sur le rétroviseur pour bien le positionner. 2.Tournez le rétroviseur jusqu’à ce qu’il soit bien aligné avec la référence ISSUE A SUBARU OF AMERICA PART NUMBER H505SFN000 DATE 6/1/2022 PAGE 4/6 9 Route mirror connector over eyesight module and slide onto connector tab Acheminez le connecteur du rétroviseur par-dessus le module EyeSight et glissez-le vers languette du connecteur 10 1. Plug jumper harness into pre-wire connector and mirror and 2. Collect and tape excess harness to sheet metal using foam tape and zip tie 1. Branchez le faisceau cavalier dans le connecteur de précâblé et dans le rétroviseur et 2. Ramassez l’excédent de faisceau puis collez-le sur la tôle à l’aide de ruban mousse et attachez-le 11 Re-install lower eyesight cover by setting up and pulling rearward Réinstallez le couvercle inférieur EyeSight en le soulevant et en le tirant vers l’arrière 12 Plug in connectors Branchez les connecteurs ISSUE A SUBARU OF AMERICA PART NUMBER H505SFN000 DATE 6/1/2022 PAGE 5/6 13 Re-install 8mm bolts Réinstallez les boulons de 8 mm 14 View of reinstalled components Vue des composants réinstallés 15 10 mm Reconnect battery. If equipped reconnect eyelet cable. Tighten bolt to 66 in-lbs. Rebranchez la batterie. Si elle en est équipée, rebranchez le câble de l’oeillet. Serrez les boulons à 66 po-lb. ISSUE A SUBARU OF AMERICA PART NUMBER H505SFN000 DATE 6/1/2022 PAGE 6/6 16 17 Using dark cloth or cardboard, completely cover forward-looking sensor. Avec un linge sombre ou un carton, couvrez complètement le capteur pointé vers l’avant. To calibrate compass reference mirror user guide. Pour étalonne la boussole, reportez-vous au manuel du rétroviseur.
SEOCONTENT-END